Advanced NDT Services

CR is an indirect image capture method that uses Storage Phosphor Imaging Plates (IP) instead of conventional film.

Visual Inspection relies upon the detection of surface imperfections using the eye or remotely.

Ferrite test is accurate way to measure delta ferrite content in austenitic and duplex stainless steel.

TOFD inspection is an advanced ultrasonic technique which allows for the location and sizing of defects.

DRT is a type of imaging using X-rays or Gamma rays , This method uses numeric radiation sensors instead of traditional photo film.

Hardness is a characteristic of a solid material expressing its resistance to permanent deformation, penetration.

Holiday testing or Continuity test is a non-destructive test method applied on protective coatings.

MFL is a magnetic method of Non-Destructive Testing that is used to detect Corrosion, Pitting and Wall Loss in Storage Tank Floors.

LRUT is an advanced non-destructive examination technique that was developed for testing large volumes of material from a single test point.

PMI can determine the alloy composition of materials and is a well-established technique.

Vacuum Box Testing is a test method that is used to detect leaks , It is a practical way of testing.